Accessories For Controllers
The 1070 remote control panel works for all our 1070 series controllers. This
includes our LGCII, Servo Setup Controller and Throttle controller. It is ideal
for operating and programming your controller after it is built in and the
pushbuttons are no longer accessable.
Thomson Automation- all rights reserved 2010
Download the user's manuals here.
Wheels-up Switches
These switch harnesses can be used with both our
Landing Gear Controllers. They provide an interlock
to keep the doors from trying to close before the
wheels are retracted. This is a great way to make
your gear cycle insensitive to retract speed
variations due to inconsistant air pressure or wind
loading on the gear. Available in 1, 2 or 3 switch
versions. Includes actuating magnets.
Remote Control Panel
The 1070 serial interface adapter works for all our
1070 and 1099 series controllers. This includes our
LGCII. It is for use together with our manager
software for each controller. The Serial Adapter
consists of a USB serial port and an adapter for the
controller. The adapter can be purchased separately if
you have a serial port available. Download and install
the USB Adapter driver here before plugging in your
adapter to a USB port for the first time.
Serial Adapter
These landing lights use power-LEDs and can
be used for scales from 1/15 to 1/3 depending
on the vehicle. The outside diameter of the
lens is 20mm.One will plug directly into the
1070 series Landing Gear Controller. Two
landing lights can be connected to one 1070
controller using the Landing Light Splitter
Cable.
High-power Landing Lights
You will need this cable to connect two landing
lights to one of our 1070 series Landing Gear
Controllers. The cable uses universal servo
connectors and can be easily extended using
servo extention cables.
Landing Light Splitter Cable
You will need this power switch if you use our
High-power Landing Lights together with our
LGCI. Our LGCII can be connected directly to
the lights using the splitter cable. This switch
can also, by special order, be used with other
power leds.
Landing Light Power Switch
If you are using a Landing Light Power Switch,
you will need a cable to connect to one of our
Landing Gear Controllers. The cables use
universal servo connectors and can be easily
extended using servo extention cables.
Use 1041LLCCBL with the 1041.
Use 1070LLCCBL with the 1070 or 1099.
Landing Light Power Switch Control Cables